A handheld, flat panel with a strong light behind it is called a PDR line board. Technicians can use this light to see the dent’s outline and any high or low places in the metal. Use a PDR line board by doing the following:
1. Use rubbing alcohol or soap and water to clean the area around the dent. 2. Place the PDR line board so that the light is shining on the dent and hold it up against the car’s body. 3. Adjust the line board so that you can see the dent’s contour and any high or low points. 4. Select a PDR instrument that is suitable for the dent’s size and location. PDR tools come in a variety of shapes and sizes, including rods, hooks, and glue pullers. 5. Place the object within the ding and use it to gently pull or push the metal back into position. Check your progress on the line board to make sure you aren’t doing any more harm. 6. Keep repairing the dent until it is completely fixed.
What Dissolves PDR Glue? Pull tabs or suction cups are fastened to the body of an automobile with PDR glue so that mechanics can remove dents. You can use a heat gun or glue remover solution to get rid of PDR glue. Use a plastic scraper to gently remove the adhesive after applying the solution and letting it sit for a few minutes. Alternately, you might reheat the glue with a heat gun and then use your fingers to peel it off. Avoid scratching the paint or the metal.
Using PDR procedures, small dents in aluminum trucks can be eliminated. The same procedures that you would use to fix dents in a car should be followed. But keep in mind that working with aluminum can be more challenging because it is a softer metal than steel. It’s possible that you’ll need to utilize PDR tools specifically made for aluminum repairs. What Materials Are Used to Make Dent Repair Tools? PDR companies sell dent repair tools, but if you have the necessary supplies and know-how, you may also create your own tools. PDR tools are frequently made of stainless steel rods, piano wire, and plastic handles. You’ll need to have a solid grasp of the PDR procedure and the kinds of tools required for various dent forms. What Is a PDR Light and How Does It Operate? A PDR light is a powerful LED light that shines on the body of an automobile to illuminate the surface. Technicians can use this light to see the dent’s outline and any high or low places in the metal. The light is typically attached to a handheld panel, such as a PDR line board, or placed on a stand. To aid specialists in getting the optimum outcomes, certain PDR lamps include programmable brightness levels and color temperatures.
Using a knockdown tool and a soft tip, you can gently tap the high point from the rear of the panel until it is level with the surrounding region during paintless dent restoration using a PDR line board. To prevent further harm to the panel, it is crucial to tap softly and with minimal pressure. By contrasting the dent with the surrounding area, the line board aids in the identification of high spots and makes it simpler to locate and remove them.