Weaving a Lobster Trap: A Step-by-Step Guide

by
How do you weave a lobster trap?
Read more on www.youtube.com

The most important instrument for lobster fishers is the lobster trap. It is braided with wire mesh and made of wood. The lobsters can be caught in the traps and kept alive until they are ready to be harvested. A step-by-step tutorial for weaving a lobster trap is provided here.

Wooden slats, galvanized wire, pliers, a tape measure, a saw, a hammer, and nails are required materials. Step 1: Trim the Slats The wooden slats should be cut to the proper width and length. Depending on the fisherman’s preferences, the size of the trap might change. The slats are typically trimmed to be 2 feet long and 1 foot wide.

The second step is weaving the wire mesh. To match the size of the wooden slats, measure and cut the wire mesh. Make sure the mesh is taut and secure when you weave it between the slats. To guarantee a snug fit, bend the wire as necessary with pliers.

Secure the Mesh in Step 3

To the wooden slats, nail the wire mesh. To fasten the mesh to the slats, use a hammer. To prevent the mesh from coming undone, make sure the nails are hammered in deeply enough.

Attach the Bait Compartment in Step 4

On one of the slats, make a little hole in the center. This will serve as the bait container. To prevent the bait from escaping the chamber, fasten a piece of wire mesh inside.

Step 5: Include the Escape Hatch On the top of the trap, cut a little hole in the mesh. Smaller lobsters that can’t be harvested use this as an escape route. The gap ought to be just big enough for the smaller lobsters to get through.

How to Build a Wire Crab Trap

A common substitute for lobster traps is wire crab traps. They are simple to manufacture and useful for collecting crabs. A step-by-step tutorial for building a wire crab trap is provided here.

Supplies Required:

Galvanized wire, pliers, wire cutters, rope, and more Cut the wire in the first step. To the required length, cut the wire. Depending on the fisherman’s preferences, the size of the trap might change. The wire is typically trimmed to be 2 feet long and 1 foot broad.

The second step is weaving the wire mesh. Make sure the mesh is taut and secure when you weave it through the wire frame. To guarantee a snug fit, bend the wire as necessary with pliers.

Secure the Mesh in Step 3

To ensure that the edges are smooth and to cut any extra wire, use wire cutters. To make it simple to hoist the trap out of the water, tie a length of rope to the top.

Add the Bait Compartment in Step 4

To hold the bait in place, attach a little piece of wire mesh inside the trap. To draw the crabs, the bait must be put in the middle of the trap.

In conclusion, it takes perseverance, accuracy, and attention to detail to weave a lobster trap or construct a wire crab trap. You can make your own fishing-related traps by following the detailed instructions in these manuals. It is crucial to remember that traps need to be constantly examined to make sure they are not catching other marine creatures that needs to be released back into the ocean.