Removing Acrylic from an Old Tanning Bed: A Guide

Tanning beds, especially older versions, frequently need upkeep and repairs to keep them operating at their best. The requirement to replace the acrylic, the plastic barrier that is placed between the bulbs and the user, is one of the most frequent problems with tanning beds. Acrylic is susceptible to cracking, scratching, and discoloration over time, which can reduce the tanning bed’s efficiency and perhaps endanger the user. Here are some suggestions to make it easier and safer for you to remove acrylic from an outdated tanning bed.

Make sure you have the appropriate tools for the job first. A screwdriver, pliers, and a utility knife or scraper are required. Start by unplugging the tanning bed and cleaning the acrylic barrier of any loose dust or debris. Any screws or bolts keeping the acrylic in place should be removed using the screwdriver. Depending on the design of your tanning bed, you might have to completely remove the top or bottom to get to the acrylic. Once the screws have been taken out, carefully lift the acrylic shield away from the tanning bed frame. As you remove the acrylic, take care to avoid bending or cracking it. You can use a moderate soap and water solution or a specialized acrylic cleaner to clean acrylic that is severely soiled or stained. Avoid using corrosive cleaners or abrasive scrubbers since they can harm the acrylic’s surface.

The bulbs in tanning beds should be changed every 500 to 1000 hours of use, or around once per year. The UV power of the bulbs will diminish over time, which could result in uneven tanning and longer exposure times. It could be time to change the bulbs if you discover that your tanning bed is taking longer to provide the intended effects or emitting an odd stench.

Depending on the model and manufacturer, assembling a stand-up tanning bed may be difficult. When installing your tanning bed, it’s crucial to carefully read the directions and adhere to all safety measures. In general, you’ll need to put the frame together, connect the electrical parts, and attach the acrylic shield and lights. It may be preferable to seek professional advice if you are unsure about any step of the assembly process. How are tanning bed bulbs cleaned?

Make sure the tanning bed bulbs are off and have fully cooled before cleaning them. To remove any dust or dirt from the surface of the bulbs, use a soft, dry cloth. Water and cleaning agents should not be used as they may damage the bulbs. You can use a specialized UV bulb cleaning on the bulbs if they are very soiled or discolored, or you can speak with the manufacturer for more information.

The electrical parts of a tanning bed must be connected to a power source in order to be set up. When installing your tanning bed, it’s crucial to adhere to all safety regulations and local construction regulations. Typically, you must install a GFCI outlet and attach the bed to a separate 220-volt electrical circuit. It is important to speak with a certified electrician if you are unclear of how to connect your tanning bed.